S15/T15 Jimmy 2WD V6-4.3L VIN W (1998)
Fuel Line Coupler: Service and Repair
With Plastic Collar
Removal Procedure
1. Grasp both sides of the quick-connect fitting. Twist the female connector 1/4 turn in each direction in order to loosen any dirt within the
quick-connect fitting.
Caution: Wear safety glasses when using compressed air because flying dirt particles may cause eye injury.
2. Using compressed air. blow any dirt out of the quick-connect fitting.
3. Squeeze the plastic retainer release tabs.
4. Pull the connection apart.
Installation Procedure
Caution: In order to Reduce the Risk of Fire and Personal Injury: Before connecting the fuel pipe quick-connect fitting, always apply a
few drops of clean engine oil to the male fuel pipe end. This will ensure a proper re-connection and prevent a possible fuel leak. (During
normal operation, the O-rings in the female connector will swell, which may prevent a proper re-connection if not lubricated).
1. Apply a few drops of clean engine oil to the male fuel pipe end.
2. Push both sides of the quick-connect fitting together in order to cause the retaining tabs/fingers to snap into place.
3. Once installed, pull on both sides of the quick-connect fitting in order to make sure the connection is secure.
