S15/T15 Jimmy 2WD V6-4.3L VIN W (1998)
Knock Sensor: Service and Repair
REMOVAL PROCEDURE
NOTE: The knock sensor is located on the top rear of the engine.
1. Disconnect the negative battery cable.
2. Remove the wiring harness connector from knock sensor.
3. Remove the knock sensor from the rear of the engine.
INSTALLATION PROCEDURE
1. Install the knock sensor.
^
Tighten to 19 Nm (14 lb. ft.).
2. Install the wiring harness electrical connector to the knock sensor.
3. Connect the negative battery cable.
