S15/T15 Jimmy 2WD V6-4.3L VIN W (1998)
Air Flow Meter/Sensor: Service and Repair
Description
Description
REMOVAL PROCEDURE
1. Disconnect the 3 wire electrical connector.
2. Loosen the clamp on the intake duct.
CAUTION: Carefully handle the Mass Air Flow (MAF). Do not drop or roughly handle the MAF. Do not damage the honeywell located at the air
inlet end of the MAF. Do not touch the sensing elements. Do not allow anything including solvents and lubricants to come in contact with the
sensing elements.
NOTE: Use a small amount of GM lubricant P/N 99855406 or the equivalent in order to aid in the installation
3. Remove the MAF sensor.
INSTALLATION PROCEDURE
1. Install the MAF sensor.
2. Install the inlet ducts.
3. Tighten the clamp
4. Install the MAF sensor electrical connector.
