S15/T15 Jimmy 2WD V6-4.3L VIN W (1998)
Remove And Install Stub Shaft
2. Stub shaft (40) and valve assembly.
3. Stub shaft (40) from valve assembly, if necessary.
-
Tap stub shaft (40) lightly on a wood block to loosen shaft cap.
-
Pull cap and valve spool (41) out from valve body (43) 6 mm (1/4 inch) and disengage stub shaft pin from hole in valve spool (41).
4. Valve assembly, if necessary.
Remove And Install Spool
-
Remove valve spool (41) by pulling and rotating from valve body (43).
-
Remove valve spool O-ring seal (42).
-
Remove valve body teflon rings (46) and O-ring seals (45).
ASSEMBLE
1. Valve assembly, if necessary.
-
Install valve spool O-ring seal (42) to valve spool (41).
-
Lubricate valve spool (41) and O-ring seal (42) with power steering fluid.
