S15/T15 Jimmy 2WD V6-4.3L VIN W (1998)
NOTICE: Do not hammer on the steering wheel puller, or damage could result to the steering column.
INSTALL OR CONNECT
Important: The turn signal lever on the multifunction switch must be in the neutral position when installing the steering wheel.
1. Align the detents on the steering wheel and steering shaft, and install the steering wheel to the shaft.
2. Nut that retains the steering wheel to the steering shaft.
-
Tighten nut to 41 Nm (30 ft. lbs.).
3. Steering wheel horn contact.
4. Inflator module, refer to "Inflator Module Replacement."
5. Enable the SIR system, refer to "Enabling the SIP. System."
6. Negative battery cable.
