S15/T15 Jimmy 2WD V6-4.3L VIN W (1998)
Ball Joint: Service and Repair
Lower
REMOVAL PROCEDURE
^
Tools Required:
-
J 23742 Ball Joint Separator
-
J 9519D Ball Joint Remover and Installer Set
1. Raise the vehicle. Support the frame with safety stands.
2. Remove the tire and wheel assembly.
CAUTION: Floor jack must remain under the control arm spring seat during removal and installation to retain the spring and control
arm in position. Failure to do so could result in personal injury.
3. Place a floor jack under the control arm spring seat. Raise the jack in order to support the control arm.
NOTICE: Support the caliper with a piece of wire to prevent damage to the brake line.
4. Remove the brake caliper.
5. Remove the cotter pin and the nut.
6. Break the ball joint loose from the knuckle using the J 23742.
Important: Place a wooden block between the frame and the upper control arm in order to block the knuckle assembly out of the way.