S15/T15 Jimmy 2WD V6-4.3L VIN W (1998)
Flex Plate: Service and Repair
4L60-E Automatic Transmission
REMOVAL PROCEDURE
1. Raise the vehicle.
2. Remove the starter.
3. Remove the bolts securing the starter cover to the transmission.
4. Remove the flywheel to converter bolts.
IMPORTANT: Mark the alignment of the flywheel and the converter in order to retain a proper balance.
INSTALLATION PROCEDURE
1. Install the flywheel to converter bolts. Hand start the bolts.
-
Tighten the bolts to 63 Nm (46 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
