S15/T15 Jimmy 4WD V6-4.3L VIN W (1996)
1.
Raise vehicle.
2.
If T-Utility, remove splash shield (6 - 15 mm bolts) (Not necessary for S-Utility)
3.
While holding one of the three pulley bolts. (to prevent crankshaft movement), torque the crankshaft pulley center bolt (Figure 1) to 90 Nm (66 lb.
ft.).
4.
If T-Utility, install splash shield (6-15 mm bolts) (Not necessary for S-Utility).
5.
Lower vehicle.
6.
Install Campaign Identification Label.
Campaign ID Label & Claim Information
CAMPAIGN IDENTIFICATION LABEL
Each vehicle corrected in accordance with the instructions outlined in this Product Campaign Bulletin will require a "Campaign Identification Label".
Each label provides a space to include the campaign number and the five (5) digit dealer code of the dealer performing the campaign service. This
information may be inserted with a typewriter or a ball point pen.
Each "Campaign Identification Label" is to be located on the radiator core support in an area which will be visible when the vehicle is brought in for
periodic servicing by the owner. When installing the new Campaign Identification Label, be sure to install the clear protective covering. Additional
Campaign Identification Label can be obtained from VISPAC Incorporated by calling 1-800-269-5100 (Monday-Friday, 8:00 a.m. to 4:30 p.m. EST).
Ask for Item Number S-1015 when ordering.
Apply "Campaign Identification Label", only on a clean, dry surface.
CLAIM INFORMATION
Submit a Product Campaign Claim with the information indicated.
Refer to the General Motors Corporation Claims Processing Manual for details on Product Campaign Claim Submission.
Owner Letter
