S15/T15 Jimmy 4WD V6-4.3L VIN W (1996)
Manifold Absolute Pressure (MAP) Sensor: Service and Repair
MAP Sensor
REMOVAL PROCEDURE
NOTE: Other than checking for loose hoses and electrical connectors, the only service possible is a unit replacement if the diagnosis shows a
faulty Manifold Absolute Pressure (MAP) sensor.
NOTE: After removing the MAP sensor from the intake manifold, replace the MAP sensor to intake manifold seal.
1. Disconnect the negative battery cable.
2. Remove the electrical connector releasing the locking tab.
3. Remove the MAP sensor.
INSTALLATION PROCEDURE
1. Install the MAP sensor.
2. Install the electrical connector.
3. Connect the negative battery cable.