S15/T15 Sonoma P/U 2WD L4-2.2L VIN 4 (1995)
Wheel Bearing: Adjustments
FRONT WHEEL BEARINGS ADJUSTMENT
1. Raise and support front of vehicle.
2. Remove hub dust cover, then the cotter pin.
3. While rotating wheel assembly in forward direction, tighten spindle nut to 16 Nm (12 Ft. Lbs.) to fully seat the bearings.
4. Loosen nut to the "just loose" position, then tighten the spindle nut finger tight.
5. If either spindle hole does not line up with a spindle nut slot, back off spindle nut not more than 1/2 nut flat.
6. Install new cotter pin, then measure hub endplay. Endplay should be 0.001-0.005 inches when properly adjusted.
7. Install hub dust cover and lower vehicle.
