S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
1. Install the lock assembly to the door.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the fasteners that retain the lock assembly to the door.
Tighten
Tighten the fasteners to 9 N.m (80 lb in).
3. Connect the power actuator wiring connector, if equipped.
4. Install the outside door handle rod (2) to the lock assembly.
5. Install the outside lock rod (1) to the lock assembly.
6. Install the inside door handle rod (2) to the lock assembly.
7. Install the inside door lock rod to the lock assembly (1).
8. Install the water deflector.
9. Install the door trim panel.
10. Connect the battery negative cable.
