S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
Power Door Lock Actuator: Service and Repair
Lock Actuator Replacement - Rear Door
REMOVAL PROCEDURE
1. Raise the window to the closed position.
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
2. Disconnect the battery negative cable.
3. Remove the door trim panel.
4. Remove the water deflector.
5. Remove the inside door lock rod (1) from the lock assembly.
6. Remove the inside door handle rod from the lock assembly.
7. Remove the outside door handle rod from the lock assembly.
8. Disconnect the power actuator wiring connector, of equipped.
9. Remove the fasteners that retain the lock assembly to the door.
10. Remove the lock assembly from the door.
INSTALLATION PROCEDURE
