S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
Cruise Control Module: Service and Repair
CRUISE CONTROL MODULE REPLACEMENT
REMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the battery negative cable.
2. Disconnect the cruise control cable.
3. Disconnect the electrical connector.
4. Remove the 3 nuts that retain the cruise control module to the mounting bracket studs.
5. Remove the cruise control module from the mounting bracket.
6. Remove the 3 screws that retain the mounting bracket to the cowl panel.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the mounting bracket to the cowl panel with the 3 screws.
Tighten
Tighten the cruise control module bracket screws to 4.5 N.m (40 lb in).
2. Install the cruise control module to the vehicle.
3. Install the 3 nuts that retain the cruise control module to the mounting bracket.
Tighten
Tighten the cruise control module nuts to 9.0 N.m (6.6 lb ft).
4. Connect the electrical connector.
5. Install the cruise control cable.
