S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
Notice: Refer to Fastener Notice in Service Precautions.
3. Tighten the bolt until both locking wings draw tight against the inner wall of the engine block.
^
Tighten the bolt to 1.9 Nm (17 inch lbs.).
Important: The heater cord must not touch the following components:
^
The engine
^
The hot pipes
^
The manifold
^
Any moving components
4. Install the heater cord to the coolant heater.
5. Route the heater cord.
6. Fill the cooling system.
7. Inspect the cooling system for leaks.
