S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
Notice: Completely engage the J 38606 jaws on the valve spring. The J 38606 may slip off and scratch the valve spring. Replace the valve spring if
the valve spring becomes scratch.
11. Use J 38606 when there is not enough clearance to use J 5892-D.
12. Remove the valve keys.
13. Carefully release the spring tension.
14. Remove the J 5892-D or the J 38606.
15. Remove the valve spring cap.
16. Remove the valve spring.
17. Remove the valve stem oil seal.
Installation Procedure
Important: The LN2 Engine uses a unique valve spring seat and seal combination unit. Under no circumstances should this seal and seat unit be
replaced with a different type of seal. Use care to ensure that the valve stem seal and spring seat are not damaged during installation. Do not use
excessive force or a hammer to install the seal on the guide. The seal will go on if straight and properly lubricated using hand pressure only.
