S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
23. Remove the intake manifold bolts.
24. Remove the intake manifold nuts.
25. Remove the fuel rail bracket.
26. Remove the intake manifold.
27. If replacing the intake manifold remove the following:
^
The throttle body.
^
The fuel rail.
28. Clean the intake manifold mating surfaces.
29. Inspect the intake manifold for damage.
30. Inspect the intake manifold for cracks near compression limiters.
31. Inspect the crankcase ventilation passages in the intake manifold face for blockage and clean as necessary.
32. Replace the intake manifold as necessary.
Installation Procedure
1. Install the fuel rail if removed.
2. Install the throttle body if removed.
3. Install the intake manifold gasket.
4. Install the intake manifold.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the intake manifold bolts.
^
Tighten the bolts in sequence to 24 Nm (17 ft. lbs.).
