S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
1. Lubricate the outside of the valve guide and the valve seal with clean engine oil.
2. Using the J 38820 install the valve spring seat and seal unit onto the guide. Push and twist the valve seal into position on the valve guide until the
spring seat flange is flush with the cylinder head surface.
3. Set the valve spring in place.
4. Set the valve spring cap in place.
Caution: Compressed valve springs have high tension against the valve spring compressor. Valve springs that are not properly compressed
by or released from the valve spring compressor can be ejected from the valve spring compressor with intense force. Use care when
compressing or releasing the valve spring with the valve spring compressor and when removing or installing the valve stem keys. Failing to
use care may cause personal injury.
5. Compress the valve spring with the J 5892-D.
Notice: Completely engage the J 38606 jaws on the valve spring. The J 38606 may slip off and scratch the valve spring. Replace the valve spring if
the valve spring becomes scratch.
6. Use the J 38606 if the clearance does not permit the use of the J 5892-D.
