S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
5. Install the right side driver knee bolster bracket (2) to the steering column bracket (1) and the intermediate bracket (3).
Tighten
^
Tighten the knee bolster bracket mounting nuts (5) to 5.5 N.m (49 lb in).
^
Tighten the intermediate bracket mounting bolts (4) to 10 N.m (88 lb in).
6. Install the knee bolster.
Re-Calibrating Actuators
RE-CALIBRATING ACTUATORS
Use the following steps to perform the calibration update:
1. Turn OFF the ignition.
2. Remove the battery positive voltage circuit fuse of the HVAC Control Module.
IMPORTANT: The module memory will not clear if the battery positive voltage circuit fuse is installed in less than 60 seconds.
3. Wait 60 seconds.
4. Install the fuse.
Recirculation Actuator
REMOVAL PROCEDURE
1. Push up on the J-spring in order to release the storage compartment door.
2. Firmly pull rearward to release the recirculation actuator (2) locking tab.
IMPORTANT: The air inlet door is behind the air distribution duct.
