S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
5. Turn the J 41552 clockwise in the slots in the rotor.
6. Perform the following steps in order to remove the pulley rotor and bearing assembly:
6.1. Hold the J 41552 in position.
6.2. Tighten the puller screw against the puller guide.
6.3. Remove the pulley rotor and bearing assembly.
7. Mark the clutch coil terminal location (1) on the compressor front head. Refer to Clutch Rotor and/or Bearing Removal (HT6/HD6/HU6) or
Clutch Rotor and/or Bearing Removal (V7 - Direct Mount).
8. Install the J 33023-A on the front head of the compressor.
9. Install the J 8433-1 and the J 33025.
10. Tighten the J 8433-3 against the puller pilot in order to remove the clutch coil (2).
"For a description of the RPO Code(s) shown in this article or any of the images therein, refer to the RPO Code List found at Vehicle/Application ID".
See: Application and ID/RPO Codes
