S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
16. Use the J 6083 in order to install the following components:
^
The pulley rotor (1)
^
The retainer ring (2)
17. Install the clutch plate and hub assembly.
"For a description of the RPO Code(s) shown in this article or any of the images therein, refer to the RPO Code List found at Vehicle/Application ID".
See: Application and ID/RPO Codes
Compressor Clutch Plate/Hub Assembly Install
TOOLS REQUIRED
^
J 33013-B Hub and Drive Plate Remover/Installer
^
J 33017 Pulley and Bearing Assembly Installer
^
J 33027-A Clutch Hub Holding Tool
1. Install the shaft key into the hub key groove (4) approximately 3.2 mm (1/8 in) out of the keyway.
The shaft key is curved slightly to provide an interference fit in the hub key groove.
2. Clean the surfaces of the clutch plate (1) and the clutch rotor (2) before installing the clutch plate and hub assembly.
3. Align the shaft key with the shaft keyway in the clutch plate and the hub assembly and place onto the A/C compressor shaft (3).
