S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
Refrigerant Pressure Sensor / Switch: Service and Repair
Compressor Cut-Off/Cycling Switch
Compressor Control Switches Removal (HT6/HD6/HU6)
TOOLS REQUIRED
^
J 43600 ACR 2000 Air Conditioning Service Center
^
J 5403 Snap Ring Pliers
^
J 9553-01 O-Ring Remover
1. Recover the refrigerant using the J 43600.
2. Disconnect the electrical connector from the switch (2) in the rear head of the compressor.
3. Remove the switch retaining ring using the J 5403.
4. Remove the switch (2) from the compressor.
5. Remove the old O-ring seal from the switch cavity using the J 9553-01.
6. Inspect the switch cavity and the O-ring groove in the rear head for dirt or foreign material. Clean the components as necessary.
"For a description of the RPO Code(s) shown in this article or any of the images therein, refer to the RPO Code List found at Vehicle/Application ID".
See: Application and ID/RPO Codes
Compressor Control Switches Install (HT6/HD6)
TOOLS REQUIRED
J 5403 Snap Ring Pliers
IMPORTANT: If you reinstall an existing control switch in the compressor, use a new O-ring and a new retainer ring. An O-ring and a retainer ring is
included in a new switch kit.
