S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
Cabin Temperature Sensor / Switch: Service and Repair
INSIDE AIR TEMPERATURE SENSOR REPLACEMENT
REMOVAL PROCEDURE
CAUTION: Refer to SIR Caution in Service Precautions.
1. Disable the air bag. Refer to Disabling the SIR System in Restraint Systems.
2. Remove the left sunshade. Refer to Sunshade Panel Replacement in Roof.
3. Remove the left windshield garnish. Refer to Garnish Molding Replacement - Windshield Pillar in Interior Trim.
4. Remove the sunroof molding trim, if equipped. Refer to Sunroof Replacement in Roof.
5. Remove the left rear assist handle.
6. Remove the upper console.
7. Using a flat-bladed tool, gently pry out the air temperature sensor.
8. Disconnect the electrical connector from the air temperature sensor.
INSTALLATION PROCEDURE
1. Connect the electrical connector from the air temperature sensor.
2. Install the air temperature sensor.
3. Install the upper console.
4. Install the left rear assist handle.
5. Install the sunroof molding trim, if equipped. Refer to Sunroof Replacement in Roof.
6. Install the left windshield garnish. Refer to Garnish Molding Replacement - Windshield Pillar in Interior Trim.
7. Install the left sunshade. Refer to Sunshade Panel Replacement in Roof.
