S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
Backup Lamp Switch: Service and Repair
Manual Transmission - NV 3500
Backup Lamp Switch Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the backup lamp switch electrical connector.
3. Remove the backup lamp switch.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
Important: The backup lamp switch has pre-applied thread sealant on the threads.
1. Install the backup lamp switch.
Tighten the backup lamp switch to 37 Nm (27 ft. lbs.).
2. Connect the backup lamp switch electrical connector.
3. Lower the vehicle.
