S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
Door Switch: Service and Repair
Door Jamb Switch Replacement - Rear
REMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the battery negative cable.
2. Use a flat bladed tool in order to remove the door jamb switch from the rear door hinge-pillar.
3. Disconnect the electrical connector. Tape the wires to the body in order to prevent them from dropping into the rear door hinge-pillar.
INSTALLATION PROCEDURE
1. Connect the electrical connector.
2. Install the door jamb switch to the rear door hinge-pillar.
3. Connect the battery negative cable.
