S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
The jack and hoist lift points for the front of the vehicle are located between the front body mounts and the transmission crossmember. The jack and
hoist lift points for the rear of the vehicle are located at the front hangers for the rear springs.
The front end lift points for the floor jack are at the following locations:
^
Beneath the lower control arms, inboard from the shock absorber mounts
^
Beneath the center of the front crossmember
The rear end lift points for the floor jack are at the following locations:
^
Beneath the axle housing, inboard from the shock absorber mounts
^
Beneath the axle differential
Whenever the vehicle is lifted using a jack or a floor jack, observe the following precautions:
^
Check the wheels at the end of the vehicle opposite the end being lifted
^
Use jack stands for support. Place jack stands at the any of the following locations:
-
Beneath the frame
-
Beneath the front suspension crossmember
-
Beneath the axle
When removing major components from the vehicle while the vehicle is on a hoist, chain the vehicle frame to the hoist pads in order to prevent tip-off.
NOTE: When jacking or lifting a vehicle, do not allow the lift pads to contact any of the following parts:
^
The catalytic converter
^
The brake lines
^
The brake cables
^
The fuel lines
^
The accelerator cables
^
The transmission shift cables
Lift pad contact may damage the parts. Lift pad contact may cause unsatisfactory vehicle performance.
