S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
1. Start the new stud into the axle flange hole by pressing firmly with your hand.
2. Install a washer and thread the lug nut on the wheel stud with the flat side of the lug nut to the vehicle.
3. Tighten the lug nut in order to draw the wheel stud into the rear of the flange.
4. Remove the lug nut and washers from the wheel stud.
5. Install the brake drum.
6. Install the tire and the wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
7. Lower the vehicle.
Rear Disc Brakes
Wheel Stud Replacement (Rear Disc Brakes)
^
Tools Required
-
J 43631 Ball Joint Separator
Removal Procedure