S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
Connect the electrical connector for the solenoid to the connector on the new hose assembly.
Connect the hose with the white nipple to the vacuum source hose.
Connect the remaining hose to the shut off valve.
Install the shield covering the AIR pump.
Lower the vehicle.
Remove the coolant reservoir nut nearest the battery.
Route the new hose assembly between the battery and the coolant reservoir with the solenoid on top.
Install the solenoid bracket onto the coolant reservoir stud and reinstall the nut back into the vehicle.
Use a wire tie to keep the new hose assembly away from the engine. On four cylinder engines, tie to the AIR outlet hose. On six cylinder engines, tie to
an available hole in the radiator fan shroud.
Parts Information
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer
