S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
Headlamp Igniter Module: Service and Repair
REMOVAL PROCEDURE
CAUTION:
The high intensity discharge system produces high voltage and current. To reduce the risk of severe shocks and burns:
-
Never open the high intensity discharge system ballast or the arc tube assembly starter.
-
Never probe between the high intensity discharge system ballast output connector and the arc tube assembly.
The high intensity discharge system produces high voltage and current. In order to reduce the risk of severe shocks and burns, the battery
negative cable must be disconnected any time service work is being performed on or around the high intensity discharge system.
Refer to Battery Disconnect Caution in Service Precautions.
1. Remove the battery negative cable.
2. Remove the radiator grille from the vehicle.
3. Remove the front bumper assembly from the vehicle.
4. Remove the starter cable retaining screws and cover from the headlamp ballast.
5. Remove the retaining clip from the starter cable connector.
6. Remove the starter cable from the headlamp ballast.