S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
3. Install the ballast and ballast subplate to the ballast support bracket.
4. Install the ballast and ballast subplate fastener to the ballast support bracket.
Tighten
Tighten the ballast support bracket fastener to 8.5 N.m (75 lb in).
5. Install the body wiring harness to the ballast.
6. Install the starter cable to the headlamp ballast.
IMPORTANT: The arc tube will not energize with the retaining clip removed or improperly installed.
7. Install the retaining clip to the starter cable connector.
8. Install the starter cable cover and screws to the headlamp ballast.
Tighten
Tighten the starter cable screws to 0.7 N.m (6 lb in).
