S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
6. Remove the inflatable restraint front end discriminating sensor from the vehicle.
7. Perform the following steps in order to complete the first fastener repair:
7.1.
Remove and discard the improperly installed rivet.
7.2.
Reattach sensor with new rivet.
8. Perform the following steps in order to complete the second fastener repair:
8.1.
Remove the improperly installed rivet.
8.2.
Enlarge the mounting holes (1) in the lower radiator support to 9.0 mm (0.35 in).
8.3.
Insert and properly seat the rivnut.
NOTE: Refer to Fastener Notice in Service Precautions.
8.4.
Install sensor with screw.
Tighten
Tighten fasteners to 8.0 N.m (71 lb in).
INSTALLATION PROCEDURE
1. Install the inflatable restraint front end discriminating sensor to the lower radiator support surface.
Ensure that the arrow is pointing toward the front of the vehicle.
