S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
Throttle Position Sensor: Service and Repair
THROTTLE POSITION (TP) SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the air cleaner outlet resonator.
2. Remove the TP sensor electric connection.
3. Remove the TP sensor attaching screws (1).
4. Remove the TP sensor (2) and seal (3).
INSTALLATION PROCEDURE
1. With the throttle valve in the normal closed (idle) position, install the throttle position sensor (2) and the seal (3) on the throttle body assembly.
NOTE: Refer to Fastener Notice in Service Precautions.
IMPORTANT: Install the new TP sensor attaching screws when replacing the TP sensor.
2. Install 2 TP sensor screws (1).
Tighten
Tighten the screws to 3 N.m (26 lb in).
3. Install the TP sensor electric connection.
4. Install the air cleaner outlet resonator.
