S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
4. Remove the control valve assembly (3) and the flow control spring (2) from the pump housing assembly (1).
Assembly Procedure
1. Install the flow control spring (2) to the pump housing assembly (1).
2. Install the control valve assembly (3) to the flow control spring (2).
3. Install the O-ring seal (3) to the connector and fitting assembly (4).
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the connector and fitting assembly (4) to the pump housing (1).
Tighten
Tighten the connector and fitting assembly (4) to 75 Nm (55 ft. lbs.).
