S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
1. Install the upper control arm shaft to the upper control arm.
2. Install the control arm bushings to the upper control arm. Use the J 22269-1 and a short piece of pipe that is the same outer diameter as the rubber
bushing.
3. Tighten J 22269-1 until the bushing is positioned on the shaft and the upper control arm as shown.
The measurement should be 12.8 - 13.8 mm (0.48 - 0.52 inch) on both ends.
4. Install the washers and the nuts to the upper control arm shaft. Do not tighten the nuts.
5. Remove the upper control arm from the vise.
6. Install the upper control arm to the vehicle. Refer to Upper Control Arm Replacement.
