S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
Clutch Disc: Service and Repair
Clutch Assembly Replacement
^
Tools Required
-
J 33169 Clutch Alignment Tool
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the transmission.
3. Mark the flywheel, cover plate, and pressure plate for installation alignment.
4. Install J 33169 through the cover plate, pressure plate, and into the flywheel for support during plate removal.
5. Remove the bolts and washers securing the clutch pressure plate and cover plate to the flywheel.
6. Remove J 33169 from the plates.
7. Clean all the clutch parts with a clean, water dampened cloth in order to remove any fibers.
8. Inspect all of the clutch parts for the following conditions:
^
Wear and damage
^
Scoring and flatness with a straight edge
^
Driven plate runout
The runout must not be more than 0.508 mm (0.020 inch).
^
Scoring, gouges, and loose rivets on the friction pads
^
Oil soaked friction pads
^
Nicks, burrs, and sliding fit on all splines
^
Bending and breaks in the clutch pressure plate cover spring
Installation Procedure
