S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
8.
Install the J 8614-01 to the pinion flange.
9.
Using the J 8614-01 in order to hold the pinion flange stationary, remove the following components:
^
The drive pinion gear nut
^
The drive pinion gear washer
10.
With the J 8614-01 still installed to the pinion flange, use the forcing screw in order to remove the drive pinion gear flange/yoke (1).
Important:
Do not damage the rear axle housing when removing the drive pinion gear seal.
11.
Use a blunt chisel in order to drive the drive pinion gear seal out of the rear axle housing.
12.
Inspect the sealing surface of the drive pinion flange/yoke for the following conditions:
Tool marks
^
Nicks
^
Grooves from the drive pinion oil seal
13.
If the drive pinion gear flange/yoke is damaged or grooved, replace the drive pinion gear flange/yoke.
14.
Inspect the housing bore for burrs. Remove any burrs that might cause leaks around the outer diameter (OD) of the drive pinion gear seal.
Installation Procedure