S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
7.
Tighten the pinion nut while holding the J 8614-01.
Tighten
Tighten the nut until the pinion end play is removed.
Rotate the pinion while tightening the nut to seat the bearings.
8.
Measure the rotating torque of the pinion. Compare this measurement with the rotating torque recorded during removal.
Tighten
Tighten the nut in small increments, as needed, until the rotating torque is 0.40-0.57 N.m (3-5 lb in) greater than the rotating torque recorded
during removal.
9.
Once the specified torque is obtained, rotate the pinion several times to ensure the bearings have seated. Check the rotating torque and adjust if
necessary.
10.
Install the propeller shaft. Refer to Propeller Shaft
Replacement - One Piece (SI2000 Document ID # 678184) or Propeller Shaft Replacement - Two Piece (SI2000 Document ID # 678187) in
Propeller Shaft.
11.
Install the brake drums (if equipped).
12.
Install the brake rotors (if equipped). Refer to Brake
Rotor Replacement - Rear in Disc Brakes (SI2000 Document ID # 724629).
13.
Install the brake calipers (if equipped). Refer to Brake Caliper Replacement - Rear in Disc Brakes (SI2000 Document ID # 526299).
14.
Install the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation in Tires and Wheels (SI2000 Document ID # 539493).
15.
Inspect and add axle lubricant to the axle housing, if necessary. Refer to Lubricant Level Check in Rear Drive Axle (SI2000 Document ID #
718210).
16.
Lower the vehicle.
