S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
1. Install the screws securing the boot to the panel.
Tighten the screws to 2 Nm (18 inch lbs.).
2. Install the shift lever to the shifter.
3. Install the console and the 3 console nuts (If equipped).
Tighten the nuts to 2 Nm (18 inch lbs.).
Shift Tower Replacement
Shift Tower Replacement
Removal Procedure
Important:
^
Ensure that the shift lever is positioned into the mechanical third or fourth gear prior to removal of the shift housing from the transmission. The
transmission must remain in this state when the shift housing is removed.
^
Do not disassemble the transmission shift housing. Internal parts for this shift housing are not available. Opening the shift housing voids the
warranty.
^
When removing the shift housing from the transmission, use the exposed bolts on the base of the housing.
^
If equipped, remove the 3 console nuts and console.
