S15/T15 Sonoma P/U 2WD V6-262 4.3L VIN W CPI (1994)
Remove or Disconnect
1. Negative battery cable.
2. Dipstick.
3. Raise the vehicle and support with safety stands.
4. Drive belt splash shield.
5. Front axle shield.
6. Front skid plate.
7. Drain engine oil.
8. Flywheel cover.
9. Left motor mount through bolts.
10. Right motor mount through bolts.
11. Raise the engine. Block in position.
12. Oil cooler line.
13. Oil filter adapter.
14 Pitman arm bolt.
15. Pitman arm.
16. Idler arm bolts.
17. Idler arm.
18. Front differential through bolts.
19. Front propeller shaft
20. Roll differential forward.
21. Starter bolts.
22. Starter motor and lay aside.
23. Oil pan bolts, nuts, and reinforcements.
24. Oil pan and gasket.
25. Clean sealing surfaces on the engine and oil pan.
26. Inspect pan gasket. Replace if necessary.
Install or Connect
1. Apply sealant to the front cover to block joint and to the crankshaft rear seal to block joint. Apply the sealant for about 25 mm (1 inch) in both
