S15/T15 Sonoma P/U 2WD V6-262 4.3L VIN W CPI (1994)
Installing Rotor & Bearing Assembly
Reassemble the Rotor and Bearing assembly to the front head of the compressor using Rotor & Bearing Installer J 26271-A. With Installer
assembled to the Universal Handle J 29886, as shown in the illustration, force will be applied to the inner race of the bearing and the face of the
rotor when installing the assembly onto the front head of the compressor.
5. Install rotor and bearing assembly retainer ring, using Snap Ring Pliers J 6083.
6. Apply sealer include GM 12345382 (Loctite 242 or equivalent) to threads of pulley rim mounting screws. Install screws but do not torque the
screws.
7. Rotate the pulley rim and rotor 10 insure that pulley rim is rotating "in-line". If pulley rim is distorted (does not rotate in-line), adjust or replace
pulley rim.
8. Tighten pulley rim mounting screws to 11 N.m (100 in. lbs.) torque and lock screw heads in place by bending screw head washer similar to
original crimp.
9. Reinstall Clutch Plate and Hub assembly.
6-Pole Clutch
1. Remove the clutch plate and hub assembly as described previously.
