S15/T15 Sonoma P/U 2WD V6-262 4.3L VIN W CPI (1994)
Oxygen Sensor: Service and Repair
NOTE The oxygen sensor has a permanently attached pig-tail and connector. This pig-tail should not be removed, since removal will affect proper
operation of the oxygen sensor.
REMOVAL
-
Disconnect electrical connector from oxygen sensor.
-
Using suitable wrench, carefully remove sensor from exhaust manifold or pipe.
Caution
The oxygen sensor may be difficult to remove when engine temperature is below 120°F. Excessive force may damage threads in exhaust manifold
or pipe.
INSTALLATION
-
If new sensor is being used, install sensor into manifold or pipe.
-
If old sensor is being reused, coat threads with anti-seize compound, Part No. 5613695 or equivalent, then install into manifold or pipe.
-
Torque oxygen sensor to 41 N-m (30 lb. ft.), then reconnect electrical connector.
