S15/T15 Sonoma P/U 2WD V6-262 4.3L VIN W CPI (1994)
2.
Remove the clutch fork and ball stud from the front transmission housing using J 36510, clutch fork pivot remover/installer (Figure 1).
3.
Inspect the front transmission housing to locate the raised boss where the grease zerk is to be installed (Figure 2).
^
The boss is on the right side of the transmission between the fill plug and the clutch fork pocket.
4.
Drill a hole of required size (determined by diameter/thread pitch of zerk used) in the center of the raised boss located in step 3.
^
The grease zerk used should have no more than 1/4" of threaded length to avoid entering the ball stud cavity.
Important:
Wall thickness in this area is approximately 1/4". Use caution to prevent passing through the ball stud cavity and drilling through the inner wall
of the housing.
5.
Tap the hole as required and install the grease zerk.
