S15/T15 Sonoma P/U 2WD V6-262 4.3L VIN W CPI (1994)
Power Window Motor: Service and Repair
Installing Bolt To Lock Sector Gear
Tool Required: J 2O922-A Rivet Installer
Remove or Disconnect
Raise the window to the closed position and secure the glass to the door frame using cloth-backed tape.
1. Negative battery cable.
2. Trim panel.
3. Water deflector from the door.
4. Electrical connector from motor.
5. Regulator and motor assembly from the window mount sash.
CAUTION: Sector gear must be locked into position. Regulator lift arm is under tension from the counterbalance spring and could cause
personal injury if the sector gear is not locked in position.
6. Motor from window regulator.
A. Install bolt and nut to lock sector gear in position.
B. Drill out the motor mounting rivets.
Install or Connect
1. Motor to the regulator.
2. Rivets to the motor and regulator using tool J 20922-A. Install 4.8 mm (3/16 inch) rivets.
Important Remove nut and bolt used to lock the sector gear in position.
