S15/T15 Sonoma P/U 2WD V6-262 4.3L VIN Z TBI (1995)
5. Shield onto the coil.
6. Retainer.
7. Lubricate the lower housing bushing with a few drops of engine oil.
8. Shaft assembly into the housing.
9. Tang washer, washer, and driven gear onto the bottom of the shaft.
^
Align the marks on the driven gear, housing. and shaft assembly.
10. Roll pin into the gear.
^
Spin the shaft and make sure the teeth on the shaft assembly do not touch the pole piece.
11. Rotor onto the shaft.
^
Fit the tab in the rotor into the shot on the shaft.
12.
Cap to the housing with screws and washers.
