S15/T15 Sonoma P/U 2WD V6-262 4.3L VIN Z TBI (1995)
Throttle Body: Service and Repair
Fuel Meter Cover Assembly
Fuel Meter Cover Assembly
The fuel meter cover assembly contains the fuel pressure regulator assembly. The regulator has been adjusted at the factory and should only be serviced
as a complete preset assembly.
CAUTION: DO NOT remove the four screws securing the pressure regulator to the fuel meter cover. The fuel pressure regulator includes a
large spring under heavy compression which, if accidentally released, could cause personal injury. Disassembly might also result in a fuel leak
between the diaphragm and the regulator container.
Fuel Meter Cover Replacement (TBI 220)
Remove or Disconnect
1. Electrical connectors to fuel injectors. (Squeeze plastic tabs and pull straight up.)
2. Long and short fuel meter cover screw assemblies.
3. Fuel meter cover assembly.
NOTICE: DO NOT immerse the fuel meter cover (with pressure regulator) in cleaner, as damage to the regulator diaphragm and gasket could
occur.
4. Fuel meter outlet gasket and pressure regulator seal. Discard gaskets and seal.
INSPECT:
^
For dirt, foreign material and casting warpage.