S15/T15 Sonoma P/U 2WD V6-4.3L VIN W (1996)
2WD Pitman Arm
INSTALL OR CONNECT
TOOLS REQUIRED:
^
J 29193 Steering Linkage Installer (12 mm).
1. Pitman arm on the pitman shaft. Line up the marks made at removal.
2. Pitman arm washer and nut.
TIGHTEN
^
Pitman arm nut to 250 Nm (185 lb. ft.).
3. Relay rod ball stud to the pitman arm. Make sure the seal is on the stud.
^
Tighten J 29193 or J 29194 to 62 Nm (48 lb. ft.) to seat the tapers. Remove the tool.
4. New relay rod prevailing torque nut to the pitman arm.
TIGHTEN
^
Nut to 82 Nm (60 lb. ft.).
5. Lower the vehicle.
