S15/T15 Sonoma P/U 2WD V6-4.3L VIN X (1998)
10. Lower the vehicle to the proper height.
11. Remove the front tire to gain access to the rear exhaust manifold bolts.
12. Remove the fender wheelhouse extension.
13. Disconnect the spark plug wires from the spark plugs.
14. Remove the exhaust manifold bolts and the stud.
15. Lower the vehicle.
16. Remove the exhaust manifold and the spark plug wire shields from the engine.
17. Clean all gasket surfaces.
INSTALLATION PROCEDURE
1. Sub-assemble the spark plug wire shields, bolts, and NEW gaskets to the exhaust manifold. The stud installs in the front hole.
2. Raise the vehicle to the proper height.
3. Install the exhaust manifold to the engine.
4. Connect the spark plug wires to the spark plugs.
