S15/T15 Sonoma P/U 2WD V6-4.3L VIN X (1998)
7. Remove the lower control arm out of the opening in the splash shield. Use a putty knife or a similar tool in order to guide the control arm past the
splash shield.
8. Remove the grease fittings.
9. Remove the lower ball joint from the lower control arm using the tools as shown. Replace the parts as necessary.
10. Inspect the tapered hole in the steering knuckle. Remove any dirt. If the tapered hole is out of round, deformed or damaged, replace the knuckle.
INSTALLATION PROCEDURE
^
Tools Required:
-
J 9519D Ball Joint Remover and Installer Set
1. Install a new ball joint into the lower control arm.
