S15/T15 Sonoma P/U 2WD V6-4.3L VIN X (1998)
IMPORTANT: If replacing the engine flywheel note the position of the original balance weights (if applicable). Balance weights must be installed
into the new engine flywheel in the same location.
1. Note the position of the engine flywheel balance weights and install the engine flywheel balance weights as required.
A properly installed engine flywheel balance weight will be flush or slightly below flush with the face of the engine flywheel.
2. Install the engine flywheel to the crankshaft.
3. Align the locator hole to the pin.
NOTICE: Refer to Fastener Notice in Service Precautions.
4. Install the engine flywheel bolts.
-
Tighten the engine flywheel bolts in sequence to 100 Nm (74 ft. lbs.).
5. Install the clutch assembly.
