Safari Van 2WD V6-4.3L VIN X (2003)
8. Remove the plate from the trim panel.
9. Disconnect the electrical connectors from the switches on the plate, as needed.
10. Remove the door courtesy lamp from the door panel, if equipped. Refer to Courtesy Lamp/Reflector Replacement - Door .
11. Use J 38778 to release the door trim panel retainers.
12. Remove the trim panel from the door.
Installation Procedure
Important: Replace any trim panel retainers that were damaged during removal.
1. Position the trim panel to the door.
2. Secure the trim panel retainers to the door by pressing into the door until fully seated.
3. Place the window seal portion of the panel over the door frame in order to install the trim panel to the door.
4. Install the door courtesy lamp to the door panel. Refer to Courtesy Lamp/Reflector Replacement - Door .
5. Connect the electrical connectors to the switches on the accessory switch mounting plate, as needed.
6. Install the plate to the trim panel.
Notice: Refer to Fastener Notice in Cautions and Notices.
7. Install the one screw at the front edge of the accessory switch mount plate.
Tighten the one screw at the front edge of the accessory switch mount plate to 2 N.m (18 lb in).
8. Install the handle to the door with screws.
Tighten the handle to the door with screws to 5 N.m (44 lb in).
9. Install the caps that cover the screws on the assist handle.
10. Insert the tab in the slot on the door trim panel and seat the fastener into the door at the top in order to install the upper corner trim.
11. Push the lock lever escutcheon into place, starting at the rear edge.
12. Install the window regulator handle, if equipped.
