Safari Van 2WD V6-4.3L VIN X (2003)
1. Install the step panel cover.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the step panel cover screws.
Tighten the step panel cover screws to 2 N.m (18 lb in).
Mat/Carpet Replacement - Front Floor
Mat/Carpet Replacement - Front Floor
Removal Procedure
1. Remove the seats and the risers. Refer to Seat Replacement - Bucket (See: Seats/Service and Repair/Seat Replacement - Bucket) .
2. Remove the engine cover, if required. Refer to Engine Cover Replacement (See: Access Cover/Service and Repair/Removal and
Replacement/Engine Cover Replacement) .
3. Remove the trim plates from the front door openings. Refer to Carpet Retainer Replacement (See: Carpet Retainer Replacement) .
4. Remove the cowl side panel trim. Refer to Trim Panel Replacement - Cowl Side (See: Trim Panel/Service and Repair/Trim Panel Replacement -
Cowl Side) .
5. Remove the throttle pedal guard.
6. Remove the screws from the center floor air duct.
7. Remove the center floor air duct.
8. Remove the front side door lock pillar garnish molding, if required. Refer to Garnish Molding Replacement - LF Lock Pillar (See: Trim
Panel/Service and Repair/Garnish Molding Replacement - LF Lock Pillar) .
9. Remove the carpet/mat from the vehicle.
Installation Procedure
